Smoke, not heat, is what normally stops people reaching an exit, which is why classification systems carry a separate smoke subscript. This guide separates the three families of smoke measurement, shows how ISO 5659-2, ИСО 5660-1 и RU 13823 each produce a different number, explains how smoke growth rate and total smoke production become an s1, s2 or s3 class under EN 13501-1, and sets out how to match the method to the market you sell into.

Fire testing standards for interior building materials split by product category before they split by country. Wall and ceiling linings, floorings and linear products each follow their own test programme. This guide maps the European route through EN 13501-1, В 13823 and EN ISO 11925-2, the North American route through ASTM E84 and ASTM E648, and the Chinese GB 8624 system, then sets out the substrate and end-use rule that overrides every one of them, plus the gaps that most often derail a submission.

A cone calorimeter test measures how much heat a burning specimen releases, how quickly, and what else comes off it. This guide catalogues the nine outputs the instrument produces — heat release rate, peak heat release, общее тепловыделение, time to ignition, mass loss rate, effective heat of combustion, smoke production, specific extinction area and gas yields — explains how oxygen consumption calorimetry derives them, which irradiance settings change every number, where the results are used in EN, ASTM and GB frameworks, and what the instrument does not measure.

Flame spread testing measures how far and how fast a flame travels across a material surface once ignited. There is no single universal method: five cover almost every regulatory requirement. This guide separates flame spread from ignitability and heat release, walks through the tunnel test, the Single Burning Item test, lateral flame spread, the radiant panel methods and small-flame ignitability, then shows how to choose a method by target market, which variables the laboratory controls, how to read each reported quantity, and the mistakes that invalidate results.

МЭК 60695 is not one test but a family of fire hazard test methods, and the product standard rather than IEC 60695 decides which method applies and at what severity. This guide maps the series by ignition source, separates GWEPT from GWFI and GWIT, sets out what changed in the 2021 editions, explains why a V-0 datasheet is not compliance evidence for a finished assembly, and gives the sequence in which to run the tests and specify the equipment.